When sony you wish to use with a plug other than an XLR 5-pin type, sony consult an authorized Sony representative.
MIC ON, oFF 1) Camera number sheet/tally indicator, lights red when the red tally signal sony is input (e.g.
4) incom (intercom) input/output/setting section, incom (intercom) connector (XLR 5-pin Headset connector for sony a headset.MIC/PGM (program audio) manual switch: ON: The headset microphone is switched.Front Panel, camera number sheet/tally indicator 1, power, cAM, mAIN, nCOM.Priv: The producer line and engineer line are disabled and communication is restricted to that between the CCU- 550/550P and the camera connected to its rear manual panel.ENG: Selects the engineer line.PGM: Program audio is output.The indicator illuminates green when the green tally signal is input (e.g.Camera connector on the rear panel of the CCU- 550/550P, or manual when the load current is extremely low even when a camera cable is connected. Alarm, oPEN, short, pROD, manual pREV, pGM, pGM.
2) power switch/CAM (camera) and manual main indicators.
When the manual video signal from the manual camera connected to the CCU-550/550P goes on air).
3) cable alarm indicators, oPEN: illuminates manual when a triax cable is not connected to the.When the call button on the camera, an MSU-700, RCP-700 Series.When this position is selected, manual the incom level control adjusts the output level of the program audio.The main and sony CAM indicators illuminate when the power switch is turned.When the video signal from the camera connected to the CCU-550/550P goes off air).Remote Control panel or an optional BKP-5973 (CCU-550/550P Front.Panel) is pressed, the lamp is illuminated if it was not lit, or is turned off if it was already illuminated.Short: illuminates when there is excessive current flow in the triax cable.Attach the supplied number sheet here to indicate the camera number.Incom selector: Selects the routing of intercom signals output/input through the incom/tally/PGM connector.The CAM indicator goes out when the power is turned off by the CAM PW button on the remote control panel or the master set-up unit, or by the CAM power switch on the internal AT board.Prod: Selects the producer line.Incom input/output/setting section 4 Location and Function of Parts and Controls 3 cable alarm indicators incom level control: Adjusts the input level of the intercom.This power switch turns the power supply on and off to the entire camera system, including the CCU-550/550P, the camera and the remote control unit connected to the remote connector of the.Power switch/CAM and main indicators 2, cable.