Siras-se 7 D 79 10 NCU ULU Neumev-erstfasse 9u 0 8500 nurnberg Ch cm ms P 1*-* pn Pac*aro GmbM rns-req Bu'.
This will preset both the HP 8756A and the HP 8350B (this will also turn the HP 8350B ljmod on and set the sweep rate to 200ms).Note See Table 1-2 for detector response variation with temperature 2-20.OUT Return Loss.04 to IS GHz Figure 4-7.Instruments covered BY manual 1-9.This manual contains operating and service information for the Hewlett-Packard Model 11664A detector.Power Splitters 1-3 1-32.Remove the two pozi-drive screws on the cable end plate of the HP 11664A.On one connector, retract the coupling sleeve by turning the coupHng nut counterclockwise until the sleeve and nut disengage.If the RF connector is, or has been replaced by, an APC-7 type connector, refer to Figure 2-1 for user instructions.00 dB CHls A/R cracked bitdefender internet security 10 -.35 dB strt - -Olooghz MKR.0400GHz stop.0400GHz Figure 4-4.Order the assembled connector (J1 in Table 6-3 from your nearest Hewlett-Packard office.Properly Adjusted Trace 4-4 4-4.Directional Bridges 1-3 1-30.MO 20850 Tet (301)258-2000 midwestern USA Hewlett-Packard Co 5201 ToKvtew Drive ROOiNG meadows.A double wall carton made of 350-pound test material is adequate.4-4A - Performance Tests 4-8.
Instruments Covered by Manual 1-1 1-11.
The HP 11667A power splitter provides this function from DC to 18 GHz.
The best method of preventing ESD is for the operator to wear a grounding strap connnected to a conductive bench mat that provides a path to ground of between 1 and.5 Megohms.